Page EN-36
Troubleshooting table
Problem
Possible cause
Solution
The LED (2) is illu-
minated, although dis-
hwasher salt has been
added.
The dishwasher salt is clum-
py.
Stir the dishwasher salt using the
end of a spoon or similar.
The water is not run-
ning or it is running
only very slowly.
There is a kink in the inlet
hose.
Arrange the inlet hose properly so
that it is not kinked (see “Connect-
ing the inlet hose” on page EN-30).
The water tap is not properly
on.
Turn the water tap on completely.
The water is not run-
ning off or only very
slowly.
The filters are blocked.
Clean the filters (see “Check-
ing and cleaning the filters” on
page EN-27).
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
Lay out the outlet hose in the prop-
er manner (see page EN-30).
The dishwasher is not
watertight.
The door seal is defective.
Have the door seal replaced (see
“Service” on page EN-38).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced
(see “Service” on page EN-38).
The dishwasher can
be switched on/off, but
cannot be operated.
The dishwasher can only be
operated when the appliance
door is closed.
Close the dishwasher door.
The dishwasher cannot
be operated.
The buttons are locked.
Unlock the buttons (see “Button
lock” on page EN-26).
The dishwashing results are not satisfactory
Problem
Possible cause
Solution
There are residues or
streaks on the dishes.
The rinse aid is incorrectly
dosed.
Adjust the dispensed dose (see
“Adding dishwasher salt” on
page EN-15).
The dishwasher salt is deple-
ted.
Add dishwasher salt (see “Adding
dishwasher salt” on page EN-15).
The dishwasher salt is clum-
py.
Stir the dishwasher salt using the
end of a spoon or similar.