Page EN-32
Set-up, connection, installation and initial start-up
Degree of water hardness
Hard water will cause calcification within the
dishwasher. Also, more dishwasher detergent
will be required to clean the dishes.
Soft water increases foaming.
For this reason, the degree of hardness of
the water has to be determined and adjusted
even before the first use. You can determine
the water hardness from your water bill or
enquire about the degree of hardness at the
water supply company.
The appliance is factory-set to a hardness
level of “H3”.
Adjusting the water hardness level
(12)
(9)
(10)
1. Close the dishwasher door.
2. If the dishwasher is switched on,
switch it off.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button (1).
2. Press and hold the
P
button (12) until the
LEDs
(9) and
(10) flash alternately.
Please refer to the following table for the
relevant water hardness setting:
°dH
LED display
Setting
0-5
H1
6-11
H2
12-17
H3
18-22
H4
23-34
H5
35-55
H6
3. Press the
P
button (12) repeatedly until
the required hardness level is displayed.
4. Around 5 seconds after you push it for the
last time, the dishwasher will automatical-
ly revert to the normal display.
The hardness level setting is saved.
