Page EN-30
Set-up, connection, installation and initial start-up
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve’s lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slowly
and ensure that no water is escaping.
Then close the valve again.
Connecting the dishwasher to
the electricity
WARNING!
Electric shock / fi re hazard!
■
Prior to connecting the dishwasher,
ensure that you have page EN-4 tak-
en note of all the safety instructions
and adhered to them.
Depending on the recess into which the dish-
washer will be fitted, the dishwasher should
be connected before or after fitting.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of
a sufficient size (230 V~/50 Hz/10 A).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
– We recommend using a pulse-sensitive re-
sidual current device (RCD).
• Insert the mains plug into the socket.
Substructure
NOTICE
Risk of damage!
Selecting the wrong screws can dam-
age the worktop.
■
Select the correct screws with the
appropriate screw length.
■
Use the enclosed screws.
44.8 cm
60.0 cm
84.5 cm
Requirements
– Only install the dishwasher underneath a
continuous worktop which is joined to the
units adjacent to the dishwasher.
– Maintain sufficient distance from the walls
and adjacent appliances. The measure-
ments of the recess must at least corre-
spond to the details in the diagram above.
