Start-up
Page EN-26
Installing the appliance
If you have to change the door hinge of
the appliance due to space constraints,
or if you want to change the door hinge
for other reasons, you must change the door
hinge before installation (see “Changing the
door hinges” on page EN-29).
For installation, you will need a PH2 cross-tip
screwdriver.
Fitting the appliance into the cabinet
1. Switch off the fuse for the intended sock-
et. Then insert the mains plug into the
socket.
2. Slowly and carefully push the refrigerating
appliance into the built-in cabinet. Make
sure that the side to be opened is as close
as possible to the wall of the cabinet.
Mounting the runners and slides
There are holes pre-drilled in the outside edg-
es of the appliance door for the slides (19) to
be attached.
(25)
(19)
(21)
1. Use short screws (25) to attach 2 sliders
each per door on the sides to be opened.
2. Push the runners (21) into the slides (19).
Close and open the cabinet door to check
that it closes fully and easily. If necessary,
correct the position of the refrigerator.
3. Open the appliance door and cabinet door
at the same time. As you do so, mark the
best position for the runners on the inside
of the cabinet door.
(25)
(21)
4. Remove the runners from the slides
again.
5. Use 2 short screws (25) to fasten each of
the runners to the insides of the cabinet
doors in the marked positions.
6. Press the covers (22) onto the runners.
(21)
(19)
7. Unscrew the slides again and push them
onto the fitted runners.
