Installing, connecting and start-up
Page EN-31
Inserting the oven
NOTICE
Risk of damage!
Improper handling of the appliance
can result in damage.
■
Do not set the oven down on the edge
or corner of the oven door! The glass
panes can be damaged.
1. Push the oven into the recess until the
front fascia is flush with the installation unit.
The mains connection must not be kinked,
pinched or otherwise damaged.
2. Ensure an even gap between the oven
and the unit walls on both sides.
3. Do not seal the gap above the oven fascia.
4. If the oven is correctly set up, open the
open the oven door and screw it to the
built-in cupboard using the included as-
sembly material. Use the screws and the
spacers.
5. Switch the socket fuse back on.
Basic cleaning
The oven must be pre-cleaned to remove all
grease and oil residues from the manufactur-
ing process, as well as tough dust deposits
left over from storage and transportation. This
not only helps protect your health but also en-
sures delicious cakes and roasts.
1. Operate the oven with dripping pan, oven
rack and baking tray for 60 minutes at
250 °C.
Refer to the chapter “Operating the oven”
for the oven’s operating instructions.
2. Allow the oven to fully cool down.
3. Clean the cooking compartment of the
oven, as well as the dripping pan, oven
rack and baking tray with a little soapy
water and then wipe everything dry.
Attaching the telescopic
extensions
The package contains a set of telescopic ex-
tensions. The telescopic extensions make it
easier to insert and remove the oven rack,
baking tray and dripping pan.
Inserting the shelves
The extensions are labelled with an “L” for left
and an “R” for right. Note the page number
when attaching to the baking tray guides.
1. Remove the oven rack, the baking
tray and the dripping pan.
2. Remove the baking tray guides as de-
scribed in the section “Cleaning the bak-
ing tray guides”.
R
R
Summary of Contents for HBO7213PA1
Page 42: ...Seite DE 42 ...
Page 84: ...Page EN 42 ...
