Page EN-33
Installation, connection and initial commissioning
– The ground must be secure, even, clean
and dry .
– It is not appropriate to have a rug or car-
pet under the appliance, as the appliance
will not be ventilated well enough and can
overheat .
For use on rugs, carpets, parquet or wood-
en floorboards, place a stable wooden
board underneath the appliance (measur-
ing at least 40 × 60 cm) .
If it is placed on a wooden plate or base,
the screw-on feet should be fixed so that
the appliance does not dislodge itself when
spinning .
Lay a smooth tiled floor or rubber mat un-
der the screw-on feet .
Aligning the appliance
(31)
(21)
1 . Loosen the lock nut (31) of one of the screw-
on feet (21) underneath the appliance .
2 . Using your hand, screw the foot (21) in
or out as far as necessary . To adjust the
foot, twist it
– anti-clockwise to unscrew .
– clockwise to screw in .
3 . Repeat this for the other screw-on feet
until the appliance is standing completely
horizontally and securely .
4 . Twist the lock nuts of all screw-on feet
upwards to the underside of the machine
and tighten the lock nut against the un-
derside of the machine .
Water connection
Establish drain for water
WARNING
Risk of scalding!
Improper handling of the appliance
can lead to scalding caused by hot suds.
■
Fix the hose to the sink or bath to pre-
vent it from slipping due to the recoil
caused by pumping.
■
For drains, make sure that the
cross-section of the discharge pipe is
great enough that the drain cannot
overflow.
NOTICE
Risk of damage to property!
Improper handling of the appliance
can lead to water damage.
■
Use only the water outlet hose pro-
vided.
■
Do not extend the water outlet hose
or replace it with another hose.
■
The water outlet hose must not get
bent or twisted.
■
The curvature of the water outlet hose
must be at least between 60 cm and
100 cm above the ground to ensure
the water drain functions perfectly.
■
The water outlet hose must be in the
retaining clips on the back of the ap-
pliance so that the bend on the hose
always remains above the waterline
inside the appliance. The end of the
hose must not be submerged in the
pumped water.
