Cleaning the oven
Page EN-23
3. Carefully removed the metal grid.
b
c
d
f
e
e
a
4. The top pane
b
is fixed in the grid plate
by three small rubber holders
a
. Do not
lose these rubber holders.
5. Remove the upper pane
b
from the
mounts below the hinges and carefully
set it down.
6. Remove the middle pane
c
and place it
down gently. Be sure not to damage the
rubber seals on the side.
7. Remove the lower pane
d
and place
it down gently. Ensure that you do not
damage the side rubber seals here as
well.
There are also two rubber holders on
this pane
e
– do not lose these either.
8. Clean all panes
b
,
c
and
d
with warm
clean water.
9. Dry the panes thoroughly.
10. Slide the bottom pane
d
into the lowest
position of the holder on the hinge.
11. Make sure that both side rubber seals
and both rubber holders
e
are positioned
correctly.
12. Slide the middle pane
c
back into the
holder. Make sure that the side rubber
seals are positioned correctly.
13. Re-insert the inner pane
b
again.
14. Put the three rubber holders a back on
the top edge of the pane
b
.
15. Put the grid plate back on top of the door
– it only fits in one direction.
16. Firmly press the grid plate onto the door
and tighten it with the two screws.
17. Replace the oven door (see „Replacing
the oven door on its hinges“ on page
EN-22).
Summary of Contents for 2013C(G)3.334eETsPrDpHbJX
Page 46: ...Seite DE 46 ...
