HANSCRAFT IN.K300, User Manual

Page: 12 / 24

12
Control panel
LIGHT
(hold for 5 seconds)
5.7 Programming the filter/purge cycles
Depending on system configuration your spa will perform either a filter or a purge
cycle. The filter cycle menu consists of the following parameters: the start time
(FS), the duration (Fd) and the frequency (FF). The purge cycle menu consists of
the following parameters: the start time (FS) and the frequency (FF). A filter cycle
consists of starting all the pumps and blower in high speed for 1 minute (purge step)
then, the pump associated with the filter will run in low speed for the remaining
duration of the filter cycle (clean step). A purge cycle is used when the spa is
equipped with a 24 hour circulation pump which provides a continuous clean step. It
consists of starting all the pumps and blower in high speed for 1 minute.
5.8 Setting filter or purge cycle start time
The display will show FSXX, “XX” representing the starting hour of the cycle. Use
the arrow keys to adjust the hours. Use the Lights key to jump to the next parameter,
filter duration (Fd).
5.9 Setting filter cycle duration
(not available on purge systems)
The display will show Fdxx, “XX” representing the duration in hours of the filter
cycle. Use the arrow keys to adjust the duration. Use the Lights key to jump to the
next parameter, filter or purge frequency (FF).
PM
12 48
FS03