HANSCRAFT IN.K300, User Manual

Page: 10 / 24

10
Control panel
5.2 Start or stop accessories
To start or stop an accessory, press the corresponding button. The indicators light up
when the associated accessory is turned on. If the accessory has more than two states,
press the button until it reaches the desired state. The indicators will flash when the
two-speed pumps are switched on at low speed and will light up at high speed.
5.3 Water temperature
The temperature shown on the screen is the current water temperature. Use the
ARROW Up and ARROW Down buttons to set the desired temperature. The set point
icon will appear at the top of the screen. After 3 seconds without any change to the set
temperature value, the keypad will resume the normal display.
JETS The button is used for quick control of massage jets. In case it
doesn't run filtration, the JETS button must be pressed twice. The
power of water flow nozzles can be adjusted by turning the nozzles
left or right. If so water does not flow through the nozzle, it does
not have to be a fault, the nozzle can only be closed. Not all nozzles
can be regulated in this way. It is also possible to regulate the force
of the massage with the massage engine running, by turning the
valve sucking air into the nozzles located at the upper edge of the
whirlpool.
LIGHTS This button allows switching the lights on.
ARROW UP The arrow up allows selecting an option.
ARROW DOWN The arrow down allows selecting an option.
98f
5.4 Off Mode
Pressing JETS for 5 seconds will enable the Off mode. This mode allows you to stop
all outputs including automatic functions such as filter cycle, heat request and smart
winter mode for 30 minutes to perform quick spa maintenance. When Off mode is
active, the display will toggle between the “OFF” message, the clock and the water
temperature. The spa light will flash for a few seconds before the end of the