ATTENTION:
Please follow these steps when operating the first time :
1.Open valve and charge water
2.Make sure that the pump and the water-in pipe have been filled with water
3.Close the valve and start the unit
4.2
Installation
(1)
The heat pump unit must be installed by professional technicians .otherwise unit may be damaged or body injured,
even dead
(2)
The unit is designed for outdoor location with good ventilation. Recirculation of cold discharge air back into
evaporator coil will greatly reduce heating capacity and efficiency of the unit, which will void the compressor
warranty.
(3)
The unit can be installed almost anywhere in the outdoors
.
To get a good performance ,it needs to meet the three
factors :
a) Good ventilation
b) Stable and reliable power supply
c) Recycled water system
The difference from gas water heater, it should not bring environmental pollution or have the installing problems
in-windy areas.
(4)
The unit should not be installed in a limited air ventilation area ,or placed in a bush where it will block the air inlet .
These location deny the unit of a continuous source of fresh air .When seasons changing ,it may stick leaves on
the evaporator coil ,thereby reducing its efficiency and impact of its service life .
(5)
For indoor installation, please consult more instruction from technicians.
(6)
When install a bypass, it should be not exceed 30% of nominal flow rate
(7
Must make Water level higher than the circulation pump location.
(8)
Below picture show the minimum required distance on each side of pool heat pump unit.
Air
inlet
Air
outlet
!
POOL HEAT PUMP
04
Summary of Contents for Evolution 25
Page 1: ......
Page 19: ...10 Exploded Diagram POOL HEAT PUMP 17 ...
Page 21: ...POOL HEAT PUMP NOTE ...
Page 22: ......