Hansa BHMI62135, Instruction Manual

Page: 7 / 36

7
INSTALLATION
EN
5
Notes for the technician
Instalator powinien:
l
The fitter should:
l
Bear a valid certificate of gas permit
l
Have studied the contents of the appliance’s type plate containing the suitable type of gas. Compare the data
with the characteristics of the gas available in the network.
l
Check the following:
• ventilation capacity, incl. air exchange in the kitchen,
• tightness and sealing of the gas fittings,
• effectiveness and correct operation of all the functional elements.
l
Adjust the settings of the gas control knobs with the washers included to ensure the igniters work properly and
the entire system is leak-proof;
• check the operation of the igniters and leak seal,
• remove the knob if working incorrectly, and adjust bi introducing washer(s) onto the valve spindle,
• check the operation of the igniters and leak seal,
• secure the system with a tight washer and put the knob handle on.
l
Issue a certificate of connecting the appliance and inform the user of the operating activities.
NOTE! Installation and service must be performed by a qualified and licensed installer, service agency or
gas supplier. All the relevant safety regulations must be observed.
The cooktop is equipped with an R1/2” connecting pipe for gas connection. If the appliance is intended for use with LPG
(propane – butane), a Ø 8 x 1 mm hose coupling is threaded onto the connector.
Make sure the gas connecting pipe does not come in contact with the metal components of the cooktop.
All the couplings and joints must be tightly sealed.
Note. After connecting the appliance check all fittings for gas leaks e.g. with soapy water.
Do not check the fittings with open fire!
Please make sure you have read and understood the entire operating manual. Do follow the instructions to ensure
safe and effective operation of your cooktop.
NOTE: The appliance uses gas, which is a flammable and explosive substance. Thus, it is necessary for the cooktop
to be connected to a gas network which supplies the gas type for which the appliance is suitable.
Installation and service must be performed by a qualified installer, service agency or gas supplier.
Please check the type plate for the information concerning the suitable gas type for your appliance.
Converting the unit to another gas type
Only a licensed and authorised technician may carry out this job.
If the available gas type is different from that provided in the type plate of the appliance (G 20 (GZ 50) 20 mbar, the
burner nozzles should be replaced and flame adjusted.