2
English
Technical Information
Water pressure
Recommended
15 - 75 PSI (0.1 - 0.5 MPa)
Maximum
145 PSI (1 MPa)
Hot water temp.
Recommended
120°-140° F*(48° -60° C*)
Maximum
158°F*(70° C*)
Max. flow rate
1.2 GPM (4.5 L/min)
74527xx1, 32528xx1
0.5 GPM (1.9 L/min)
Hole size in mounting surface
spout
1³⁄₁₆"-1⁵⁄₁₆"(30 mm - 34 mm)
valves
1³⁄₁₆"(30 mm)
Max. depth of mounting surface
1³⁄₁₆" (30 mm)
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• The drain is suitable for most, but not all, lavatory
sinks sold in the United States and Canada.
• The drain is intended for use in a sink with an
overflow. If your sink does not have an overflow, or
if this drain is too small for the hole in your sink,
please refer to the instructions included
with the sink
. Some sinks include special drain
installation instructions and/or parts. Others require
the use of a specialty drain. Hansgrohe is not
respnsible for the cost of a specialty drain.
•
Models 32518xx1, 32519xx1, 74518xx1,
74519xx1 only
: This faucet does not include a
drain or a pull rod.
• The hot and cold supply hoses included with this
faucet are for use with ⅜ stops. If your stops are
a different size, purchase adapters at your local
plumbing supply store or home center. Adapters are
not available from Hansgrohe.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
