10
11
Thermostatic Adjustment
Temperature Limitation
The temperature is limited by the safety stop to 40°C.
If a higher temperature is required, it is possible to
over ride the safety stop by depressing the safety
button.
NB.
It is recommended that for
private domestic
use
the maximum mixed water temperature be set
at the following factory set values:
Shower Mixer 43°C
Bath/Shower 46°C
The desired maximum temperature (43°C) can be
pre-set using the safety function.
Proceed as follows:
1. Remove the handle end cap, undo the screw and
pull off the handle and safety set disk. Remove
the circlip from the spindle and slide off the
locking ring (fig.1).
2. Turn the spindle until the required maximum
temperature is reached (43°C). You will need
to use a thermometer (fig.2).
3. Replace the locking ring back onto the spindle
as shown. Refit the circlip (fig.3).
4. Refit the safety set disk as shown. Replace the
handle, screw and end cap (fig.4).
To guarantee a smooth running of the thermostatic
element, it is necessary from time to time to turn
the thermostat from total hot to total cold. The
thermostatic mixer valve should be checked annually
by a qualified person to ensure correct operation.
The mixer is fitted with check valves (page 14 pos. 4)
and filters (page 14 pos 7). If the water flow drops
the filters need to be cleaned. For that purpose the
mixer has to be removed from the wall.
SW 3 mm
SW 3 mm
1
2
3
4
