12
• Then confirm the displayed digit
with
and move to the next one.
• When the whole password has been
inserted, press CFM to confirm it.
Note
The default password is set at “0000”.
• The LCD will display “SET” on the
upper part and “c.00” on the low-
er, allowing the user to edit setup
parameters (see table below).
• Enter the code of the parameter you want to set, using the
arrow keys as per the password procedure above (e.g.41).
• Confirm the code by pressing CFM and the default or the
previously memorized value will be displayed with the first
digit blinking.
Note
When the password is not inserted or a wrong password is
confirmed, the display will only show the previously memo-
rized value, without blinking (read only mode). In this case,
the value cannot be set. Press LCD and start again.
• Enter the desired value using the arrow keys and then
press CFM.
