31
30
TO CHANGE THE INK CARTRIDGE
When printouts become faint, it might be necessary to change the ink
cartridge. Contact your dealer or the nearest Hanna Customer Service
Center for this.
TO INSERT PAPER ROLL
HI 9161
,
HI 9261
and
HI 91610
use plain 38 mm wide paper rolls.
To insert a new roll gently pull out the printer cover.
Take out the used paper cylinder.
Insert the paper edge in the printer slot and feed the paper through
by pressing the PAPER key.
PRINTER MAINTENANCE
PRINTER MAINTENANCE
PRINTER MAINTENANCE
PRINTER MAINTENANCE
PRINTER MAINTENANCE
PAPER
HI 92000
allows use of commonest spread sheet programs (e.g. Excel,
Lotus 1-2-3) and offers a variety of features with an on-line help routine.
To install
HI 92000
,
you need a 3.5" drive and a couple of minutes to
follow the short instructions conveniently printed on the disk label.
HI 9161
,
HI 9261
and
HI 91610
are factory programmed to
automatically diagnose a fault and inform the user by displaying an
error code on the LCD.
Error codes are:
PEr0, PEr1, PEr2 = Short circuit on the system, the meter should be
returned for repair (see Warranty).
PEr3 = Printer mechanism fault - repair needed (see Warranty).
PEr4 = Printer clutch jammed - reset the printer (see page 32).
PEr9 = Printer jammed - reset the printer (see page 32).
SELF-DIAGNOSTIC FUNCTIONS
SELF-DIAGNOSTIC FUNCTIONS
SELF-DIAGNOSTIC FUNCTIONS
SELF-DIAGNOSTIC FUNCTIONS
SELF-DIAGNOSTIC FUNCTIONS
Capacity: 8000 data samples which are divided into 16 pages.
Capacity per Page: up to 500 data.
Each time a new logging mode is entered, the meter automatically goes
to the next available page. Once all 16 pages are used up, the meter
will overwrite the first lot. During logging, the meter automatically
returns to the oldest page in the memory and if it contains data, it will
overwrite it. In this case the first log will not correspond to the oldest set
of data. It is recommended to periodically “clean” the memory. Save
data into a PC if you need to keep a record and then disconnect the
batteries for about 1 minute. If you do this, remember to reset the time
and date, once the batteries have been reinserted again.
ATTENTION
Data is stored into memory until batteries are removed. If replace-
ment of the batteries is needed and data is not to be lost, first plug
in an external 12VDC power supply and then proceed with battery
replacement as described on page 33. Only once batteries have been
replaced, it is possible to unplug the power supply without losing the
previously memorized data.
MEMORY ORGANIZATION
MEMORY ORGANIZATION
MEMORY ORGANIZATION
MEMORY ORGANIZATION
MEMORY ORGANIZATION
(HI 91610 only)
Excel
©
Copyright of "Microsoft Co."
Lotus 1-2-3
©
Copyright of "Lotus Co."