15
14
PARAMETER SETTINGS
• Once the parameter code (and password if
needed) has been entered, the current
value of the selected parameter will be
displayed on the primary LCD and the
parameter code on the secondary one. The parameter or a part of it
will blink (e.g. only the hour blinks if time has been selected).
• Enter the new value using the arrow keys.
• If there is another part of the parameter to be set (e.g. minutes
for the time), press DISPLAY to gain access and then enter the
new value using the arrow keys.
• Press CFM to confirm the value.
• If the entered value is not acceptable, the "WRONG" indication
will be displayed for a few seconds and then the meter will ask for
a correct value.
• If the confirmed value is accepted, the meter will pass to the next
parameter (asking for the password if it is protected).
Note:
If (ALT+) SETUP are pressed before parameter value confir-
mation, the meter will not update the parameter and after
escaping will ask for a new setup code.
The following table lists the setup codes along with the description of the
specific setup items, their valid values and the factory settings (default):
Code
Valid values
Default
00 Instrument ID code
0000 to 9999
0000
01 Current time
1
hh:mm
00:00
02 Current date
1
dd.mm
01.01
03 Current year
1
YYYY
1998
10 Calibration alarm time-out
01 to 99 days , OFF
OFF
20 Auto-Off/Power down time-out ON, OFF
ON
21 Firmware version
22 Battery level test
90 HI 504910 terminal mode
99 Password
2
0000 to 9999
0000
Setup can be used to view data regarding instrument status (e.g.
battery charge) or to change the meter parameters (e.g. time).
• To enter this mode press (ALT+) SETUP
while the meter is in measurement mode.
• The setup code "00" will blink on the
secondary LCD and "SEt" will be dis-
played on the primary one.
• Select the code of the desired
parameter using the
or
key.
• Press CFM to confirm the code.
Note:
If (ALT+) SETUP are pressed before code confirmation, the
meter returns to measurement mode.
• If the selected parameter is password protected, the lower LCD will
display "PAS" and the password must be entered to proceed.
Otherwise, the current parameter value will be displayed.
PASSWORD PROTECTION
Setting of time, date and calibration alarm time-out are password
protected and the user will be asked to enter the password to change
these parameters. After code confirmation the upper LCD will display
"0000".
• If password is set to 0000 (factory setting), just press CFM to
confirm.
• If password is set to a value different from 0000, enter the
password with the up and down arrow keys and then press CFM
to confirm.
• If the password is not correct, the meter displays the "WRONG"
indication and asks for the password again.
• If the password is correct, the meter provides access to the
parameter.
SETUP MODE