38
3. Hydraulic transmission fluid level
Open the inspections cover and pull out the
oil scale. Inspect if the fluid level is within the
mark of the gauge.
4. Mast and forks
Check the mast and forks to make sure:
①
There is no crack and bend on the forks,
and the forks are installed on the fork
bracket strongly;
②
Check if there is oil leakage on the cylinder
and tubing;
③
Check the rollers‘ rotation;
④
Check the mast if there are cracks or
bends;
⑤
Operate the lifting, tilting and attachment
lever, check the mas
t if it‘s in good
condition, and pay attention to system
operating sound.
5. Lift chain tension check
①
Raise the fork about 10-15 cm above the
ground and make it vertical.
②
Press middle of the chain by thumb. Make
certain the tension for the right and left
chains are even.
③
Adjust the tension: Loosen the lock nut 1,
screw the nut 2 and adjust the chain to make
the equal tension, and then screw down the
lock nut 1.
6. Lubrication of mast
Lubricate the following parts periodically
according to the requirements of lubrication
sheet
①
The periods of paint lubrication grease
depend on the truck‘s work condition. If work
is heavy, please paint much more grease on
mast.
②
To assist with the truck‘s operation,
paint some lubrication grease on the surface
where the idler pulley and inside and outside
masts touch.
Paint some lubrication grease on bearing
guide rail.
