13
Step 6.
Thread a 2-56 clevis on the end of one of the threaded
rods. Screw the clevis on 7-10 turns. Install the clevis with wire
on the control horn into the third hole from the mounting base.
Be sure to install the clevis keeper (piece of fuel tubing) over
the clevis.
Step 7.
With the linkage attached to the control horn, center the
control surface and hold the linkage wire directly over the elec-
tronically centered servo arm. Place a mark on the rod directly
over the hole (second hole from the end of arm) in servo control
arm that it will connect too.
Step 8.
Make a “Z” bend in the rod at the location you just
marked.
Step 9.
Insert the “Z” bend through the second hole from the
end of the servo arm. Install the clevis back onto the control
horn. Be sure to slide on the silicon clevis keeper onto the end
of the clevis.
Step 10.
Repeat the process for the other aileron linkage.
