34
Hangar 9 P-51 PTS Mk II Assembly Manual
Step 18
Insert the flap linkage into the outer hole you enlarged earlier.
Rotate the linkage to face toward the flap control horn.
Step 19
Attach the clevis to the flap control horn center hole. Plug
the flap servo lead into the servo leads on the Y-harness.
Turn on the transmitter and receiver. Position the flap switch
to the “NORM” position as shown. With the radio in the
programming mode for FLAPS, adjust the percentage using
the Rolling Selector to set the “UP” position of the flap so it
is aligned with the trailing edge of the wing.
Reduce photo to 13.5%
FLAPS
FLAP ELEV
NORM≤
0
0
LAND 0 0
List
Step 20
With the radio system still on, position the flap switch to
the “LAND” position as shown. With the radio still in the
programming mode for FLAPS, adjust the percentage using
the Rolling Selector to set the “LAND” position of the flap so
there is a measurement of 1-inch (25mm) as shown in the
image below.
Reduce photo to 13.5%
FLAPS
FLAP ELEV
NORM 0 0
LAND≤
0
0
List
