31
Hangar 9 P-51 PTS Mk II Assembly Manual
Step 2
Use a #1 Phillips screwdriver to remove the servo cover
from the wing. Set the screws with the linkage for later use.
Step 3
Use a hobby knife to score the flap stay on both sides. You
only need to go across the stay a couple times to weaken it.
Bend it side to side a couple times and it will break free.
Step 4
Turn on the radio and plug a Y-harness into the Aux1 port on
the main receiver. Plug the flap servo into one of the servo
leads of the Y-harness. Turn on the transmitter and receiver
to center the flap servo. Position the servo arm on the servo
so it is centered as shown in the images below.
Note
: Accessing the receiver to plug in the Y-harness
is covered in Section 11: Binding on Page 14 of this
manual.
Step 5
Position the flap servo on the flap servo cover so the servo
arm is centered in the opening on the cover as shown.
