Section 16: Linkage Installation
37
Step 16
Install one of the #2 x 3/4" screws in a hole drilled,
then remove it. Place 2-3 drops of thin CA into the
hole to harden the wood. This will eliminate the
potential of the screw pulling out of the wood. Repeat
this for each of the three holes.
Step 17
Attach the control horn using three #2 x 3/4" screws.
Step 18
Center the aileron servo electronically using the radio
system. Install a servo arm onto the aileron servo.
Attach the pushrod with clevis to the control horn.
Physically place the aileron control surface in
neutral. Mark the pushrod where it crosses the holes
in the servo arm.
Step 19
Bend the wire 90 degrees at the mark made in the
previous step. Cut the wire 1/2" above the bend.
Step 20
Slide the wire through the outer hole in the aileron
servo arm. Secure the wire using a nylon wire keeper.