34
Section 16: Linkage Installation
Required Parts
• Wing assembly
• Nylon clevis (5)
• Clevis retainer (5)
• Fuselage assembly
• Nylon wire keeper (5) • 18
3
/
4
" pushrod wire
• 2-56 x 1/2" screw (6) • Nylon control horn (4)
• 7
7
/
8
" pushrod wire (4)
• #2 x 3/4" sheet metal screw (6)
Required Tools and Adhesives
• Drill
• Drill Bit: 1/16", 3/32"
• Phillips screwdriver (small)
Step 1
Slide a clevis retainer onto a nylon clevis. Thread a
clevis onto a 7
7
/
8
" wire a minimum of 10 turns.
Step 2
Remove the back plate from a control horn using side
cutters or a sharp hobby knife.
Step 3
Position the control horn on the elevator so the
horn aligns with the hinge line of the elevator. Mark
the position for the mounting holes using a
felt-tipped pen.
Step 4
Drill three 3/32” holes through the elevator at the
locations marked in the previous step.