STEP 5 Attach the Table Bed to the A-Frame
• Face the front of the A-Frame where the Crossbar is located (refer to Figure 13 to determine
A-Frame Front).
• Grasp both the Roller Hinges, right above the Cam Lock, and lift the Table Bed. Allow the top
of the Table Bed to rotate toward the floor, so that the back of the Table Bed is now facing
you and the top of the Table Bed is in front of the Crossbar (Figure 14).
• Lower each Roller Hinge Pivot Pin into the A-Frame hinge plates, one side at a time
(Figure 15). The Self-Locking Hooks will open to allow the Pivot Pin into the Hinge Plate slot,
then automatically snap closed over the Pivot Pin.
TIP:
You may need to push outward on the Hinge Plate in order for the second Pivot Pin
to lock in place.
• Make sure that each Pivot Pin is seated at the base of the slot in the Hinge Plates, and that
the Self-Locking Hooks have closed over both Pivot Pins (Figures 15a & 15b).
• Rotate the Table Bed into the use position (Figure 16). Ensure that it rotates smoothly.
FIGURE 13
FIGURE 14
FIGURE 15
FIGURE 16
FIGURE 15a
TOP VIEW
FIGURE 15b
INSIDE VIEW
Failure of the Self-Locking Hooks to close over both Roller Hinge
Pivot Pins is an indication of improper assembly and if not corrected
could result in serious injury or death!
WARNING
!
FRONT
BACK
14
