42
Picture4.17 PPPOE setup
Input the user name and password that ISP
（
Internet service provider
）
provides. After saving it reboot up your
system. Then the DVR will build a network connection based on PPPoE. The IP address will change into
dynamic IP address after above operation is well done.
Operation
：
After PPPoE dialing successfully look up the IP address in the [IP address] and obtain the current
IP address. Then use this IP address to visit the DVR through user port.
【
NTP setup
】
Picture4.18 NTP setup
The NTP server must be installed in the PC.
Host computer IP
：
Input the IP address installed NTP server.
Port
：
Default: 123. You can set the port according to NTP server.
Time zone
：
London GMT+0 Berlin GMT +1 Cairo GMT +2 Moscow GMT +3 New Delhi GMT +5
Bangkok GMT +7 Hongkong Beijing GMT +8 Tokyo GMT +9 Sydney GMT +10 Hawaii GMT-10
Alaska GMT-9 Pacific time GMT-8 American mountain time GMT-7 American mid time GMT-6
American eastern time GMT-5 Atlantic time GMT-4 Brazil GMT-3 Atlantic mid time GMT-2.
Update cycle
：
The same with the NTP server check interval. Default: 10minutes.
【
EMAIL setup
】
If the alarm is turned on or the alarm linkage photos are taken, send an email about the alarm information and
