24
Step 3: click Settings button, return the Picture 3.10 Complete setup, that is the preset points and preset
position corresponds.
Clear Preset
：
Input preset points, click Remove button, remove the preset
。
Picture 3.11 Preset Settings
2
）
Preset Point Calls
In Picture 3.10, click Page Shift button, enter PTZ control interface as shown in Picture 3.12. In the
input blank, write the preset points, then click Preset button, PTZ turn to the corresponding preset point.
Picture 3.12 PTZ Control
2
、
Cruise between Points
Multiple preset points connected cruise lines, call cruise between points, the PTZ run around on the line
1
）
Cruise Between Points Settings
Cruise lines is connected by multiple preset points, setting procedure is as follows:
Step1: In Picture 3.10, the Direction key will turn PTZ to designated location , click Settings button to
enter Picture 3.13,
Step 2: click Cruise buttons, the write proper value into the Cruise Line and Preset Points blank
，
then
click Add Preset Points button, complete setting (also can add and delete cruise line which has been set up)
Step 3: repeat step1 and step2 , until set out all the preset designated cruise lines
。
Preset button
Preset point input blank
Value input blank
