1-888-628-1730 • Mini Maxx Installation Manual 35
the diameter of the tire using a tape measure rather than going by the printed tire size. In additon,
using a GPS is a great way to dial in your factory speedometer. Entering a larger tire size will cause
the factory speedometer to read higher while entering a smaller tire size will cause the factory
speedometer to read lower. The tire size can be adjusted from 25.5” to 45”. This option only takes a
few seconds to change and can be adjusted at any time from the Tire Pressure Calibration menu.
Special functions / features
Your H&S tuning device has the capability of Enabling / Disabling factory vehicle features. These
features can be found in the Special Functions Menu. Below is a short description of each feature:
TPMS:
Enable / Disable the Tire Pressure Monitoring System.
Optical chirp on lock:
Enable / Disable the parking lights flashing when locking the vehicle.
Horn chirp on lock:
Enable / Disable the horn chirp when locking the vehicle.
Set Headlamp Delay:
Enable / Disable the headlamp delay.
accessory Delay:
Enable / Disable the shut-off delay of your radio and accessory system after the key has
been turned off.
fog lights W/High:
Enable / Disable the fog lights staying on when high beams are being used.
Daytime lights:
Enable / Disable the daytime running lights.
Seat Belt Minder:
Enable / Disable the chime for the drivers seat belt system. This feature will not dis-
able the seat belt light.
auto Door lock:
Enable / Disable the automatic door locking when the vehicle reaches certain speeds.
Unlock Driver Door:
Enable / Disable unlocking only the driver door when pushing the unlock button the key-
fob. When enabled, the unlock button on the key fob will need to be pressed twice in order to unlock all doors.
idle Up (auto Only):
Enable / Disable the use of the cruise control buttons to control idle RPM. Follow
your vehicle owners manual to use this feature
nOTE:
If any special feature is already listed as Enabled but is not functioning correctly, you may need to disable the
feature, cycle the key, and re-enable the feature to make it function properly. If it still does not work, your vehicle may
not be equipped with the hardware required for the special feature. The previous selection will NOT be saved. If the
Special Functions/Features Menu is exited and returned into, it will not display your previous selection. This is normal
and the Enable/Disable function is still working properly.
Keyed ignition Source location
Although it is possible to manually power up the Mini Maxx without using a keyed ignition source,
it can sometimes create communication issues between the Mini Maxx and the vehicles ECM. To
eliminate these problems, we highly recommend tapping into a 12V keyed ignition source to sup-
ply power to the Mini Maxx only when the key is in the ON position and the vehicles ECM is online.
Below you will find a commonly used 12V keyed ignition source for your vehicle:
Summary of Contents for Mini Maxx
Page 52: ...52 Mini Maxx Installation Manual www hsperformance com...
Page 62: ......
