TRACTORS
This operators manual uses the term “Tractor” when identifying the the power source.
W A R N I N G
TO PREVENT SERIOUS INJURY OR DEATH
Study The Above Safety Rules
ATTENTION - BE ALERT - YOUR SAFETY IS INVOLVED
BEFORE YOU ATTEMPT TO OPERATE THIS EQUIPMENT, READ AND STUDY THE
FOLLOWING INFORMATION. IN ADDITION, MAKE SURE THAT EVERY INDIVIDUAL WHO
OPERATES OR WORKS WITH THIS EQUIPMENT, WHETHER FAMILY MEMBER OR
EMPLOYEE, IS FAMILIAR WITH THESE SAFTEY PRECAUTIONS.
.
-8-
DO NOT
attempt to perform maintenance or repair with tractor running.
DO NOT
step up on machine at any time.
DO NOT
allow minors to operate or be near the machine.
DO NOT ALLOW PERSONNEL OTHER THAN THE QUALIFIED
OPERATOR NEAR THE MACHINE.
Loose or floppy clothing should not be worn by the operator.
Stop the tractor engine, remove ignition key, and allow all mechanisms to stop before cleaning,
working, or adjusting on machine.
Stay clear of hydraulic lines, they may be under extreme pressure or heat.
Stay clear of rake when opening or closing main rake arm beams, or raising or lowering rake
wheels.
For transport, always make sure that the hair pin at the rear of the lift pipes, and the transport lock
bracket with safety linch pins for main rake beam cylinders, are securely locked in place.
To reduce stress on rake arms, lift pipe, springs and spring brackets, reduce oil flow from tractor
to lift cylinders whenever possible.
Be sure to raise rake wheels before opening or closing main rake beams.
H&S Mfg. Co. always takes the operator and his safety into consideration and guards exposed
moving parts for their protection. However, some areas cannot be guarded or shielded in order to
assure proper operation. In addition, the operators manual and decals on the machine itself warn
you of further danger and should be read and observed closely.
Summary of Contents for HDII RAKE
