GB
70
Refer to the chimney installation instructions. The
following describes how the chimney system is
connected to the stove.
The stove body is prepared for top connection on delivery.
When connecting from the rear, the cover and connection
must be swapped around.
Top connection to the chimney
When connecting to the top, the whole stove surround must
be installed before installation of the chimney can begin.
Installation of the surrounds for the respective models is
described later on in these installation instructions.
The start pipe is placed over the connection on the insert.
Make sure that the gasket on the connection is intact and
in position. The stop washer is positioned over the collar on
the start pipe. Remove the small securing plate from the cuff
and thread the cuff over the stop washer. The cuff must rest
against the top of the stove. Then install the remaining parts
of the chimney and finally lock the cuff using the securing
plate. The cuff covers the lower section of the start pipe and
facilitates any service work.
Connection to the chimney
It is important that the cast top is installed on the stove before the
chimney is installed.
Cuff lock
Chimney mantle
Cuff
Stop washer
Start pipe
1
2
