Operating instructions
16
Arm-rest depth continuously adjustable
bolt A
Figure 10
1. Unscrew bolt A (if desired both left and right) one turn, see Figure 10 above.
2. Move the arm rest(s) to the desired position.
3. Tighten bolt A (if applicable, both left and right).
3.2.4 Controller
The controller housing may be used either on the left-hand side or on the right-hand side.
Depth adjustment (continuously adjustable)
adjusting
bolt
Figure 11
1. Using Allen key number 4, unscrew the adjusting bolt, see Figure 11 above.
2. Slide the controller to the desired position.
3. Tighten the adjusting bolt.
Height adjustment
The controller housing may be set in driving position or in lower position. This latter position is useful when taking place at a table.
When in driving position, the controller housing is locked. The height of the driving position is adjusted as follows:
M6 bolt
controller release
Figure 12
1. Put the controller in the lower position, see Figure 12 above.
2. Unscrew the M6 bolt, see Figure 12 above.
3. Move the pin to the desired position.
4. Tighten the bolt.
