12 |
www.HandiQuilter.com
December, 2019
11. Assemble and attach the rear
pole: Insert a rear pole endcap
into each end of the rear pole.
Attach the rear pole to the side
arm clamps. Open the clamps
by loosening the knob on the back.
Then snap in the pole and tighten
the knobs as needed.
C
NOTE
: When you put the carriage and quilting machine onto the frame, you will need to remove
the rear pole temporarily and then replace the pole, placing it through the throat space of the
machine.
12. Tighten the tracks: Place the
machine carriage on the tracks
with the encoder toward the back
of the frame.
13. Place the machine on the carriage.
The weight of the machine will
help push the tracks the correct
distance apart from each other.
14. Slide the carriage on the tracks
from side to side to fine tune the
track position. To fully fasten the
tracks to the table top, use the
4 mm hex tool to tighten the six
(6) installed M6 x 10 mm Socket
Cap Screws.
Access the three screws on each track from below the table top:
one at the left, one in the center, and one at the right (circled
above).
