Hand Held Products 4230, Quick Start Manual

Page: 15 / 24

4230 Quick Start Guide 11
The imager’s housing may also be cleaned the same way.
Inspecting Cords and Connectors
Inspect the imager’s charge adapter cable and connector for wear or other signs
of damage. A badly worn cable or damaged connector may interfere with imager
operation. Contact your Hand Held Products distributor for information about
charge adapter replacement.
Changing the 4230 Battery:
1. Remove the screw on the end cap.
2. Remove the battery from the handle.
3. Insert battery.
4. Replace end cap and screw.
Troubleshooting
The imager automatically performs self
tests whenever you turn it on. If your
imager is not functioning properly, review
the following Troubleshooting Guide to try
to isolate the problem.
Is the power on? Is the aiming illumina-
tion line on?
If the aiming illumination line isn’t illuminated, check that:
• The battery is charged.
• The trigger works.
Is the imager having trouble reading your symbols?
!
Caution:
Do not submerge the imager in water. Do not use abrasive
wipes or tissues on the imager’s window – abrasive wipes may
scratch the window.
Never use solvents (e.g., acetone, benzene, ether, or phenol-
based agents) on the housing or window – solvents may
damage the finish or the window.
End Cap