![background image](http://html1.mh-extra.com/html/hand-held-products/2020/2020_system-manual_3502015027.webp)
IMAGETEAM™ 2020/4620 System Manual
1 - 7
Connecting the Base with Serial Wedge
The IT2020-5B uses TTL signal levels to wedge into an RS-232 serial network.
Use only IT2020-5B serial wedge cables to prevent damage to the base. Refer
to
RS-232 Baud Rate
on page 2-16 to set the baud rate and communications
protocol.
1. Turn off power to the computer.
2. Disconnect the existing serial cable from the computer.
3. Connect the appropriate interface cable to the base.
Note: For the base to work properly, you must have the correct cable for your
type of computer.
4. Plug the serial connector into the serial port on your computer. Tighten the
two screws to secure the connector to the port.
5. Plug the other serial connector into the other device connection and tighten
the two screws.
6. Plug the power supply barrel connector to the base, and plug the power
supply into the AC source.
7. Once the base has been fully connected, power up the computer.
6
4
5
Other device
Summary of Contents for 2020
