HANBAY Inc
User Manual MCx-xxxDC-2.00
Page 6 of 7
www.hanbayinc.com
Rev.2019.1
1 800 315 4461
Main Dimensions
Actuator connection cable:
Select a connection cable with 6 leads.
The liquid tight strain relief on the base of the actuator is designed to accommodate a cable of
O.D. 2.5 - 6.5mm (0.10 - 0.26in)
. Be sure to not use a cable with an OD that is no bigger than this!
MC
M
-xxxDC models
MC
H
-xxxDC models
1.- Remove the
liquid tight fitting
from the actuator
casing and insert
the cable into it.
4.- Carefully insert the cable into the
actuator base. Mind the red motor cable
and its plug into the board. Moving the
plug out of its fully inserted position may
cause malfunction of the actuator
.
5.- Put the liquid tight
fitting back and tighten
(lightly with tool).
7.- Connect wires
according to your
application
(see pg 2).
2.- The cable has to
be stripped of its
jacket for 2 inches
(50mm) and the wires
need 1/8” (3mm)
stripped ends.
3.- Bend the
wires so that
insertion
becomes easy.
6.- Hand tighten the
liquid tight fitting to
establish seal.
8.- Mount actuator
cover and tighten 4
screws.
1
2
5
4
3
8
7
6
