Installing the Light Kit 8.
Figure 14
WARNING:
Before starting installation, disconnect the power by turning off the circuit breaker
or removing the fuse at fuse box.
1. Remove the 1 of 3 screws from the switch housing and keep it for future use. Loosen the other
2 screws. (Do not remove)
3. While holding the light kit under your fan, locate two single white and blue wires in the switch
housing labeled "FOR LIGHT". Make the polarized plug connections:
- White to white
- Black to black
4. Carefully push all wires back into the switch housing. Place the key holes on the light kit over
the 2 screws previously loosened from the switch housing, turn light kit until it locks in place at
the narrow section of the key holes. Secure by tightening the 2 screws previously loosened and
the one previously removed. (Fig. 14 )
5. Install 3 x 40W candelabra bulbs (not included).
6. Remove theglass cap and decorative nut from the light kit. Place glass shade over the light kit
stem, secure with the glass cap and decorative nut. Do not overtighten. (Fig. 14)
Glass shade
Switch housing
Screws
Light kit
Wire connector
Glass cap
Decorayive nut
Summary of Contents for WITHROP 656 413
Page 1: ......