7
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for mounting
□
Loosen, but do not remove, the setscrew (PP) on the collar on
top of the fan-motor assembly (D).
□
Align the holes at the bottom of the ball/downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly
(D).
□
Carefully insert the hanger pin (CC) through the holes in the
collar and ball/downrod assembly (B). Be careful not to jam
the hanger pin (CC) against the wiring inside the ball/downrod
assembly (B).
□
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrew (PP) on the collar on top of the fan-
motor assembly (D).
□
Remove the canopy ring (K) from the canopy (C) by turning
the ring to the right until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the four screws on the top of the canopy (C).
□
Remove the two non-slotted screws, and loosen the slotted
screws. This will enable you to remove the mounting bracket
(A).
□
Route the wires exiting the top of the fan motor (D) into
the decorative motor collar cover (F) and through the
canopy ring (K).
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
2
3
1
C
K
A
K
D
C
B
F
DD
CC
D
C
B
F
PP
WARNING:
Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
