5 HAMPTONBAY.com
Please contact 1-844-760-3644 for further assistance.
Installation (continued)
3
Testing the push button and
doorbell
□
Temporarily position the push button (B) and
doorbell (A) where they will be mounted.
□
Press the push button (B) to verify the
doorbell (A) and push button (B) work properly.
□
If the doorbell (A) does not sound, move the
doorbell (A) closer to the push button (B) and
test again.
NOTE:
Do not permanently mount the push button until
the push button and doorbell are working properly.
NOTE:
The push button and doorbell come synced from
the factory. The range of the wireless doorbell can vary
with location, temperature, and battery condition.
4
Mounting the push button
Use either screws (AA) or double-sided tape (BB) to
mount the push button (B).
□
To mount with screws (AA), remove the back of
the push button (B) by pushing in the tab on the
bottom with a small screwdriver. Place the push
button (B) back on the door jamb and mark the
two screw holes. Attach with screws (AA) and
snap on the front of the push button (B).
□
When attaching the push button (B) with
double-sided tape (BB), remove the paper from
both sides of the double-sided tape (BB) and
apply to a clean surface.
NOTE:
Remove material in screw holes (if needed) before
mounting with screws.
5
Mounting the doorbell
Use one of the screws (AA) to mount the doorbell (A).
□
Determine mounting location.
□
Drill one 7/32 in. (5.5 mm) pilot hole and insert
a wall anchor (CC).
□
Insert the screw (BB) into the wall anchor (CC)
leaving about 1/8 in. (3.2 mm) of the screw
threads exposed.
□
Hang the doorbell (A) on the screw (AA) using
the keyhole on the back of the doorbell (A).
VO
L
+
VO
L
–
Ligh
tS
yn
c
Musi
c
A
A
AA
B
AA
CC
