12
|
Hampton
®
H27-10 Direct Vent Freestanding Gas Stove
|
12
installation
GLASS FRONT
REMOVAL / INSTALLATION
1.
Turn off stove and allow it to return to room temperature.
2.
Lift off cast top and place on a soft surface.
3.
Remove 2 bolts using a 7/16" or 11 mm socket and lift off cast
front - place front carefully on a soft surface.
4.
Slide the light assembly bracket out of the way.
5.
Lift both latches securing glass door and remove door.
6.
To reinstall–reverse steps.
OPTIONAL WALL THERMOSTAT
INSTALLATION
1.
Open the front panel and remove the cover plate by removing two screws.
2.
Disconnect one of the wires from the switch (as shown in the picture below)
to connect it with one of the wires from the thermostat. Similarly, connect
second wire from the thermostat to one of the wire attached to IFC board.
3
. Ensure switch is set to <ON> position.
4
. Reinstall front panel.
NOTE: This appliance comes equipped with a standard remote control.
This remote control controls both the flame height and fan speed. If
using an optional wall thermostat, the functions of both the flame and
fan are disabled and cannot be adjusted.
