Hampton
®
H27-10 Direct Vent Freestanding Gas Stove
|
11
11
|
installation
OPTIONAL FAN INSTALLATION
H27-10
919-518a
10.01.15
OPTIONAL FAN INSTALLATION
1.
Turn off the stove and allow it to return to room temperature.
2.
Lift off the cast top and place it on a soft surface.
3.
Take off the back access panel by removing 2 screws as
shown in the picture below.
4.
Remove left side access panel (when facing the unit) by
removing 2 screws.
5
. Bring the fan assembly near to the unit.Connect the black
and red wires from the fan to the IFC’s black and red wire
through connectors.
6
. Secure the fan assembly wire with a strain relief on the back
of the left side access panel.
7.
Loosen the 2 bolts on fan assembly and slide the fan into the
slots provided on the unit.
8
. Once the fan assembly is fitted into the assigned slots, tighten
the bolts with a wrench.
9
. Reinstall the left side access panel, back access panel and
the cast top.
10
. Reconnect gas and power supply.
11
. To remove fan - reverse steps.
NOTE:
It is recommended to connect wires first – then install the
fan assembly to allow for more room when installing onto the unit.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your protection
against shock hazard and should be plugged directly into a properly grounded three-
prong receptacle. Do not cut or remove the grounding prong from this plug.
Strain Relief
Thermostat (Optional)
(Millivolt)
