7
HAMPTONBAY.COM
Please Contact 1-855-HD-HAMPTON for further assistance.
Care and Maintenance (continued)
Preventing Mosquitos
□ If mosquitoes are a problem in your area, it is recommended to run the fountain as much as possible to prevent
standing water, where mosquitoes breed. You may also add a few drops of anti-mosquito water treatment, available at
your local home and garden store, to the fountain water.
Preventing Water Damage
□ To eliminate water damage to floors and/or surrounding fountain areas, check for leaks and excessive splashing after
initial installation and on a regular basis.
Repairing Leaks
□ If your fountain develops a leak and a visible crack is detected, seal the crack with plastic epoxy or Clear Silicone II
sealant. If the fountain leaks without a visible crack, turn the pump off, fill the fountain and let the fountain sit for one
week. If there is a crack, it will appear white. Remember to keep the water ¾ full as water evaporates over time.
CLEANING THE FOUNTAIN
□ Do not use bleach as it may be harmful to pets and wildlife and may also damage the finish of the fountain.
□ Clean the fountain monthly to prevent mineral deposits and contamination which may clog the pump.
□ Disconnect the pump from the power source and empty the water from the fountain. Use any gentle household
cleanser and a soft brush or cloth to clean the fountain. Avoid using any harsh chemicals, abrasives or rough
scrubbing., as this could damage the finish on your fountain. The frequency of cleaning may vary depending on the
location of your fountain.
MAINTAINING THE PUMP
□ Use a pre-filter on your pump, if available, to prevent it from clogging with leaves or other debris.
□ Regular cleaning of the pump is necessary depending upon the environment in which it is operated. Clean the pump
when it is visibly soiled or when a noticeable decrease in performance is detected. Failure to clean the pump will
result in overheating of the pump.
□ Although it is not required, pumps generally last longer if left running continuously as it reduces the wear from
starting and stopping.
CLEANING THE PUMP
WARNING:
Before cleaning, always disconnect the
pump from the power source.
□ Disassemble the pump by removing the filter (1), flow regulator (2), and gland (3). Remove the impeller/rotor
assembly (4) by gently pulling on the impeller blades. Use a soft cloth or brush to clean the area inside of the pump
housing (5). Clean the flow regulator (2), filter (1), and impeller assembly (4) in warm soapy water. Reassemble the
pump and inspect for proper operation.
