REMEMBER
to disconnect the power.
The fan blades must already be attached to
the fan.
Your fan and light kit, though pre-wired,
have been disassembled at the factory to
ease in shipping. Please follow these steps
to complete the installation of your fan.
Step 1.
(Fig. 16)
Remove 1 of the 3 screws
from the
and loosen the other 2 screws. (Do
not remove)
bottom of the bottom of the motor
housing
Bring the Light Kit Housing
close to the Motor Housing, Pass the two
wires from the motor through the access
hole of the Light Kit Housing.
Step 2.
(Fig. 16)Proceed to make the wire
c o n n e c t i o n s b y s n a p p i n g t h e t w o
connectors from the motor to the two
connectors from the Light Kit Housing.
Step 4.
(Fig. 17) Place the glass shade into
the glass frame and secure with four nuts.
Step 5.
(Fig. 18)
Step 3.
(Fig. 16)
Place the key holes on the
light kit housing over the 2 screws
previously loosened from the mounting
ring, turn light kit housing until it locks in
place at the narrow section of the key holes.
S e c u r e b y t i g h t e n i n g t h e 2 s c r e w s
p r e v i o u s l y l o o s e n e d a n d t h e o n e
previously removed.
Install 1 x
14 Watt
compact fluorescent bulbs (included).
Step 6
. (Fig. 18) Take the glass shade and
glass frame assembly and place it over the
light kit housing, secure it in place by
tightening 5 screws from the light kit
housing.
Figure 16
Figure 17
Figure 18
Bulb
Installing the Light Kit 8.
