Hanging the Fan 4.
REMEMBER
to turn off the power.
Follow the steps below to hang your fan
properly:
Step 1
. Secure the hanger bracket to the
ceiling outlet box using screws included
w i t h y o u r o u t l e t b o x , l o c k w a s h e r s
included with the fan. (Fig.5)
Step 2.
Loosen the two set screws and
in the top
coupling of the motor assembly. (Fig. 6)
Step 3.
Remove hanger ball from downrod
a s s e m b l y b y l o o s e n i n g s e t s c r e w,
removing the cross pin, and sliding ball off
rod. (Fig.7)
Step 4.
Carefully feed fan wires up
through the downrod. (Fig. 8) Thread the
rod into the coupling. Next line up holes
and replace lock pin and hitch pin. Tighten
set screws.
Step 5.
Slip coupling cover, canopy cover
a n d c a n o p y o n t o d o w n r o d . ( F i g . 9 )
Carefully reinstall
remove the hitch pin and lock pin
hanger ball onto rod
being sure that cross pin is in correct
position, set screws are tighten and wires
are not twisted.
Step 6.
Now lift motor assembly into position
and place hanger ball into hanger bracket.
Rotate until the check groove has dropped
into the registration slot and seats firmly.
(Fig. 10) Rod should not rotate if this is
done correctly.
Place rubber cover onto the hanger
ball
.
Outlet box
Hanger bracket
Cross pin
Hanger
ball
Downrod
Downrod
Supply
wires
Figure 5
Figure 7
Figure 8
Figure 6
Figure 9
Figure 10
Registration
slot
Hitch
pin
Lock
pin
Set
screws
Downrod
Coupling
*Omit coupling
cover when
downrod
cover
using
the minimum-length
Canopy
Canopy cover
Hanger ball
Rubber cover
Hitch pin
Lock pin
Set screws
