2
Table of Contents
IMPORTANT SAFETY INSTRUCTIONS
Safety Information
□
□
Table of Contents ......................................2
Safety Information ....................................2
Warranty ...................................................
...................................................
3
3
3
.....................................
.....................................
....................................
3
Hardware Included
.....................................
4
Package Contents
Pre-Installation
.........................................
Installation
Operation
Care and Cleaning
........................................8
8
9
5
Troubleshooting ........................................
SAVE THESE INSTRUCTIONS
WHEN INSTALLING OR USING THIS LANDSCAPE SYSTEM, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED INCLUDING THE
FOLLOWING:
Tools Required
□
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio ortelevision reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
□
□
□
□
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
□
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
CAUTION:
Keep the lamp away from
materials that may burn.
CAUTION:
10 ft. of a pool, spa or fountain.
CAUTION:
The LEDs in this product are
not replaceable.
CAUTION:
The wire is intended for
shallow burial, less than 6 in. deep.
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
All electrical connections must be in accordance with local codes
□
Read all instructions prior to beginning the installation process.
and the National Electrical Code. If you are unfamiliar with methods
licensed electrician.
This power pack is for use with low-voltage landscape lighting
systems ONLY.
Suitable for use with submersible luminaries and pumps.
DO NOT submerge the power pack in water.
DO NOT connect two or more power suppliers in parallel.
DO NOT use the power pack with a dimmer switch.
Always disconnect the power pack from the electrical outlet
when working on the lighting system.
Power pack MUST be installed at least 20 in. above ground level.
DO NOT exceed the maximum wattage of the power pack’s terminal.
For use only on a branch circuit protected by a Class A-type
ground fault circuit interrupter (GFCI).
ONLY connect the transformer cord to a covered 120-volt Class A
type cover plate outlet that is marked “WET LOCATION”.
DO NOT repair or tamper with cord or plug.
A cord-connected landscape lighting system shall not be used
with an extension cord.
The power pack has a 30-watt circuit that powers up to 30 watts
of light.
This device is accepted as a component of a landscape lighting
system where the suitability of the combination shall be determined
by UL or CSA or local inspection authorities having jurisdiction.
Ensure that the power unit and cord do not interfere with
completely closing the receptacle cover.
□
□
□
The power pack must be installed vertically and at least 20
inches above ground level.
Use only UL listed underground low energy circuit cable or
SPT-2W. Failure to use at least 16 gauge minimum cable or
install it as directed in these instructions may result in Risk
of fire or electric shock. Using large cable will ensure
maximum light output.
FCC responsible party name : Lumitific Corporation ./address: 2850
W Horizon Ridge Parkway #200 Henderson, Nevada United States
NV89052 /Telephone number: 678-383-4085.
