MTS ROW Assembly Instructions
15
Assembly Figure 9. Connect the belts to the weight stack.
10.
Run the belts through the arm pulleys and bolt down the belts.
Thread the belts from
the weight stacks through the arm pulleys to the belt plate. With the weight stack pin in the
bottom (150 lb.) plate, pull the belt until it’s tight. Use the 3/8” x 1-1/4” bolts and plates
(circled) and tighten down the belt to 20 ft/lbs.
Cut off the belts leaving about one inch
beyond the belt plate.
Use a heavy scissors or utility knife to cut off the belt.
Assembly Figure 10. Belt routing through arm pulleys. Cut off excess.
NOTE: THE 3/8” STAR WASHERS THAT LOCK DOWN THE BELTS
TO THE ARMS WILL NEED TO BE REPLACED EACH TIME THE
BOLTS ARE LOOSENED FOR BELT MAINTENANCE.
