Hammer Strength HD SPARC, Owner'S Manual

Page: 18 / 34

Setup Complete
Calibrate Resistance Level
Perform this calibration procedure to display the correct resistance levels throughout the full range of the resistance
lever. This is required when installing the unit, replacing the console or sensor board, or if the unit has been
disassembled.
1. Press and hold the Up arrow and Down arrow for 3 seconds.
2. Navigate in the Toolbox menu to DIAGNOSTICS with the Down arrow.
3.
Press the
GO/Enter
key to enter
DIAGNOSTICS
.
4. Push the resistance lever forwards to the highest resistance level.
5. Press and hold the Up arrow for three seconds until the BRAKE VALUE section blinks. The upper value is stored.
6. Pull the resistance lever backwards to the lowest resistance level.
7.
Press and hold the Down arrow for three seconds until the
BRAKE VALUE
section blinks. The lower value is
stored.
8.
Press the
GO/Enter
key to go
BACK
to the toolbox menu.
9. Press the Down arrow to select EXIT in the setup menu.
10. Press the GO/Enter key to exit Toolbox .
Diagnostics menu
ARC TRAINER Software revision number.
PRESSURE/TEMP
Pressure: Displays Barometric pressure in HPA (hectopascal).
Temperature : Displays local temperature in degrees Celsius.
BRAKE VALUE Displays brake position value. Range is P1 to P10.
BATTERY
Displays battery level from 0 to 100% in 10% increments.
LOW BATTERY
screen
will be displayed at 10%.
Testing Operation
Use the following instructions to test the full resistance of the unit:
1. Move the resistance lever down to lowest resistance.
2. Verify foot plates are completely stopped.
3. Hold the handrails to steady self while stepping into the foot plates.
4.
Begin striding.
5.
Verify the control panel will illuminate.
Page 16 of 30