Hamilton Beach Professional 41028-CN, Instructions Manual

Page: 6 / 20

6
How to Use the Kettle
(cont.)
NOTE: The initial default actual time 0:00 is flashing, and the
default starting time is 19:99. The programming function cannot
be activated in the initial default state, so it needs to be activated
according to the above steps.
The programing function has been set. If no change is being
made to the Start Time, press the PROG button to activate the
Start Time. The light will illuminate to confirm setting. When the
Start Time equals the actual time, the Prog light will shut off and
the ON/Standby light will be illuminated. The Start Time, Preset
Time, and Keep Warm time (if it has been set) will be stored
in the memory. When water temperature reach desired preset
temperature, the base will chime two times and switch to Keep
Warm. Once the Keep Warm time has elapsed, the base will
double-chime three times and shut off.
If kettle floor discolors: It is normal for stainless steel heating
elements to discolor. This does not affect the performance of the
Kettle. Do not use abrasive scouring pads or cleaners since this
may damage the stainless steel surface.
If Kettle boils dry: The heating element is protected by two auto-
matic safety devices. If your Kettle is accidentally switched
on without being filled with water, or is allowed to boil dry, the
Kettle will automatically switch off and display and the lights will
start flashing and has the alarm sounds.
You should:
• Unplug, and wait about 20 minutes for the element to cool.
• Refill the kettle; then use as normal and check that the Kettle
functions correctly.
If Kettle does not work: Make these simple checks before calling
the customer assistance number:
• Have you pressed the ON/Standby button to ON position?
• If the Kettle heats but does not boil, it might need descaling
(see “ Care and cleaning ” section).
• Has the Kettle been accidentally turned on without being filled
with water or allowed to boil dry? Press the ON/Standby button
to standby or unplug, wait 20 minutes, and try again.
• Is cord firmly plugged into the outlet and Kettle firmly seated in
the base?
Anti-Scale Mesh Filter: Scale is caused by lime and calcium in
hard water. The Mesh Filter will prevent
these suspended particles from being
poured out of the Kettle. The filter should
be cleaned periodically to ensure opti-
mum performance.
To clean the filter, unplug Kettle and allow
to cool. Pull up on the filter tab to slide
filter out.