www.hamgadgets.com
2014-01-17
ID-O-Matic III
10
Note the last few items – specifically, the options to back up and save the configuration. I
recommend backing up your configuration (C command)
before
making any changes. You can
easily revert back to your original settings if you make a mistake – even if you’ve already saved
your changes multiple times.
Don’t forget to save changes to the on-board nonvolatile FLASH memory (W command) before
removing power or putting the ID-O-Matic in service. If you make changes and don’t save them,
they will be lost when power is removed.
There is a timeout built into the setup menu. If no keys are pressed for five minutes, the ID-O-
Matic III will return to normal operation. Note that any changes that have been made will be in
effect, but will not be saved to non-volatile memory – so they will be lost if the board is reset or
if power is turned off. If the timeout occurs before you’re finished making changes, you can re-
enter the setup menu by pressing ENTER and pick up where you left off.
Summary of Contents for ID-O-Matic III
Page 1: ...www hamgadgets com 2014 01 17 HamGadgets ID O Matic III Assembly Setup and Use Guide ...
Page 26: ...www hamgadgets com 2014 01 17 ID O Matic III 26 PCB Layout Schematic Rev C ...
Page 27: ...www hamgadgets com 2014 01 17 ID O Matic III 27 PCB Layout Schematic Rev D ...
Page 32: ...www hamgadgets com 2014 01 17 ID O Matic III 32 ...
