13
Subject to change without notice
S p e c i f i c a t i o n s
General
Mainframe with power supply accomodates any
2 modules. 4 BNC connectors on rear panel for external
interconnection to each module compartment
(Option HO801)
Module supply Voltages
2 x 8 V
AC
max. 0.5 A each
2 x 5 V
DC
max. 1 A each
4 x 20 V
DC
max. 0.5 A each
Voltages:
between 5 V and 20 V are
programmable from each
module
Polarity:
optional
Power consumption per module:
max. 25 Watt
AllDCvoltagesareelectronicalystabilized,floating
and short circuit proof.
AC test voltage to chassis:
500 V
Miscellaneous
Power switch on front panel between the two modules.
Line voltage:
115/230 V at 50 - 60 Hz
Power consumption:
max. 110 Watt
Protective system:
Safety class I (EN61010-1)
Operating temperature:
+5 °C . . . +40 °C
Storage temperature:
–20 °C . . . +70 °C
Max. relative humidity:
5% . . . 80%
(without condensation)
Size (W x H x D):
285 x 75 x 365 mm
Weight:
approx. 4 kg
TRIPLE POWER SUPPLY HM 8040-3
HAMEG
VOLTAGE
CURRENT
CURRENT
VOLTAGE
FUSE
ON/OFF
FUSE
ON/OFF
PUSH LONG
OUTPUT
Important hints
The operator is requested to carefully reading the
following instructions and those of the mainfra-
me HM8001-2, to avoid any operating errors and
mistakes and in order
to become acquaint with
the module.
After unpacking the module,
check for any mechanical damage
or loose parts inside. Should there be any trans-
portation damage, inform the supplier immedi-
ately and do not put the module into operation.
This plug-in module is primarily intended for use
in conjunction with the Mainframe HM8001-2.
When incorporating it into other systems, the
moduleshouldonlybeoperatedwiththespecified
supply voltages.
Used Symbols
ATTENTION refer to manual.
DANGER High voltage.
Protective ground (earth) terminal.
Installation
If the HM8001-2 is to be stacked with other main-
frames or HAMEG Oscilloscopes, the exact posi-
tioning is only ensured by the footrests delivered
with the instrument. These should be attached
to the top of each instrument (except the upper-
most one) using the double-sided adhesive tape
provided. Insert the footrests into the appropriate
ventilation holes on top of the lower instrument
in such a way that they correspond exactly with
the positioning of the feet on the instrument to
be stacked above. Instruments stacked in a tilted
position will now be prevented from slipping. Put
Included in delivery:
Maineframe HM8001-2, Operator's manual
Optional Accessories:
HO801 BNC connectors
HZ42
19’’ Rackmount kit 2RU
HZ809
Test Adapter
specificaTions
Valid at 23 degrees C after a 30 minute warm-up
period
