17
Attach the R-1308 Single-Axis Readout to the A-1511
Wand Bore Fixture and plug it into the readout port on
the side of the A-1519-2.4ZB Target.
Place the measuring tip against the side of
the bore so it is resting on the support leg.
Press the
Display Mode
button on the
readout to change the display to horizontal
bars. Adjust the support leg until there are
fewer than three bars showing.
Press the
Display Mode
Button again to
change the display to vertical numbers.
Adjust the measuring leg until the readings
are near .000. Slowly sweep the target in
and out until you get the highest number
reading on the readout. When you have the
highest number reading on the readout,
press the
ABS/REL
Button on the front of
the R-1308 Readout to zero the reading.
Rotate the target 180 degrees on the fixture.
Place the measuring leg against the opposite
side of the bore so it is resting on the support
leg. Press the
Display Mode
button on the
readout to display the horizontal bars.
Adjust the support leg until fewer than three
bars are showing. Press the
Display Mode
button again to display the vertical numbers.
Slowly sweep the target in and out until you
get the highest number reading on the
readout. Record that number on a sheet of
paper.
Place the measuring leg on the bottom of the bore so the support leg rest against the side of the bore.
