8
Cut lengths of angle iron to span the
top of the turbine shell or reference
bore.
•
The A-502L requires 2 pieces of
2 in. x 2 in. (50.8 mm x 50.8mm)
angle iron
•
The A-502A requires 1 piece of
2 in. x 2 in. (50.8 mm x 50.8mm)
angle iron
Insert one piece of 2 in. x 2 in. (50.8
mm x 50.8 mm) angle iron into the
magnetic mounts. Tighten the set screw
in the straight slotted magnetic mount
against the angle iron first. The rotating
slot rotates in order to absorb any
angularity that may occur when
tightening the set screws against the
angle iron. Tighten the set screw in the
rotating slot magnetic mount against the
angle iron.
Place one of each of
the magnetic mounts
(one straight slot and
one rotating slot)
approximately 5 in.
(127 mm) behind the
existing magnetic
mounts holding the
angle iron. Turn the
handle to lock the magnets. Place a second 2 in. x 2 in. (50.8 mm x 50.8 mm) length of angle iron into
the slots and tighten the set screw onto the angle iron, tightening the straight slotted magnetic mount first.
Tighten the set screw in the rotating slot magnetic mount against the angle iron.
