14
Using the T-218T 2-Axis Turbine Target
Place the T-218T 2-Axis Turbine Target
into the A-502 so the cable is on the bottom
and extends out the front and the locating
pin fits into the slot. Connect the target
cable to the R-1307 and power on the R-
1307.
If the laser beam is going into the
front opening of the T-218T 2-
Axis Turbine Target and numbers
display on the R-1307, adjust the
laser beam until the readout reads
.000 vertically and horizontally by
turning the vertical and horizontal
adjustments on the front of the L-
705 laser.
If the laser beam is
not
going into
the front opening of the T-218T 2-
Axis Turbine Target, it may be
necessary to loosen the magnetic
mounts and adjust the angle of the
laser from side to side. A vertical
adjustment can be made by the
adjusting screws on the top and
bottom of the A-502L Support
Arm. If any adjustments are made,
it will be necessary to reposition the A-502 by inserting the Bore Sweep Unit again and readjusting to the
desired set point.
On the following page is a graphic representation of the setup using the T-218T 2-Axis Turbine Target.
